RTAH

Construction

Shaft: The shaft is spun tapered from seamless 6063 alloy aluminum tubing and heat treated to a T6 temper. Round in cross-section down length of shaft and cone tapered to the butt diameter.

Hinged anchor base: Cast from A356 aluminum alloy and heat treated to T6 temper. Shaft and tilting section of the hinged base are circumferentially welded top and bottom. The tilting and anchored sections of the hinged base are joined by a 3/4" diameter solid aluminum pivot rod. The tilting section of the hinged base is held in a vertical position by three 1/2"-13 x 2" stainless steel hex head bolts that attach to stainless steel inserts cast into the aluminum base. Hinge is considered side A of the pole for orientation purposes and signifies the downward direction the pole will lower.

Anchor bolts: Fabricated from carbon steel bar with minimum-yield strength of 55,000 psi. Bolts have an "L" bend on lower end and are galvanized a minimum of 12 inches on the threaded end per ASTM A-153. Each anchor bolt is furnished with two hex nuts and two flat washers.

Grounding: Anchor base plate is tapped for 3/8"-16 UNC stainless steel grounding bolt (provided by others).

Hand hole: Available as an option; Standard location is 90° to the right (side B) of the hinge (side A) and 18” above hinged base.

Hardware – All structural and non-structural fasteners are stainless-steel.

Finish: Must specify finish.

Additional options available. Refer to RTAH specification sheet for availability.

Check out POLESCENTRAL for additional resources and solutions.

Refer to this link for Light Pole Replacement Parts